The ACI/10K-CP (Type II) Series temperature sensors are thermistor type sensors. These sensors provide a predictable output over a specified temperature range to meet each manufacturers required input values.

Thermistors offer high accuracy and interchangeability over a wide temperature range. The thermistors higher resistance relative to Platinum RTD's, creates a larger signal with the same measuring current, negating most lead wire resistance problems and eliminating the need for signal conditioners. These units are offered in Room, Room with Set Point, Room with Override, Room with Setpoint and Override, and Room w/ Setpoint, Override, and RJ11 Jack, Stainless Steel Duct and Duct without Box, Immersion, Stainless Plate, Raw, Bendable Copper and Stainless Steel Rigid Averaging, Strap-On, Bullet Probe, Button Sensor, and Outdoor Air Configurations.

• Setpoint options include a linear 400 Ohm, 1K, 2K,3K, 5K, 8.5K, 10K, 20K, or 100K slide potentiometer.
• An optional series resistor allows for any offset of the setpoint potentiometer. These may be either Direct or Reverse Acting.
• Indication stickers for setpoint include Cool/Warm, 55 to 85, and 10 to 30oC. Others are available upon request.
• Override options include a N/O switch in parallel with the sensor or a separate 2 pole terminal block for Tenant override.
• All ACI sensors can be ordered with an optional 4 pin RJ11 or 6 pin RJ12 or 1/8" RS232 Stereo communication jack with terminal blocks for remote programming.
• All units come with a two year factory warranty.

CUTSHEET     INSTALLATION INSTRUCTIONS